Below are the available bulk discount rates for each individual item when you purchase a certain amount
- Buy 6 - 11 and get $1.66 off
- Buy 12 or above and get $1.75 off
Neutrik NL4FX-Y 4 pole cable connector with chuck and Red bushing.
A new generation of loudspeaker amplifier system: SPX Series. This second generation of Speakon® connectors features a higher current rating for the operation of high power speakers and amplifiers carrying more than 1000 Watts. Change easily and quickly from a straight connector to the right-angle version, without disconnecting the cable. Only 3 parts.
Rated current/contact: 40 A rms continous, 50 A audiosignal, duty cycle 50% Dielectric strength: 4kV peak Rated voltage: 250 V ac Contact resistance after lifetime: < 2 m ohm Insulation resistance: > 1 G ohm Inrush/Outrush current capability (12v source): 300/30A/200 ms Creepage distance is according to IEC 60664-1 Mechanical Specifications:
Retention method: Quick lock with latch Lifetime (mating cycles): > 5000 Cable anchoring: NEUTRIK® chuck principle Cable O.D. range: 7.5 - 14 mm / 0.3 - 0.55" Cable retention force of >220N is subject to cable OD and material Wiring: screw-type terminals (stranded wire 5mm2/10 AWG) or soldering (stranded wire 6mm2) Solderability: complies with IEC 68-2-20 Material Specifications:
Contacts: Brass CuZn39Pb3 Locking element: Zinc diecast ZnAI4Cu1 Housing / insert: PBTP 20% GR Bushing: Polyamide PA 6 15% GR Chuck: Polyacetal POM Temperature range: -30°C to +80°C Flammability: UL94V-0 (housing), UL94HB Amplifier Wiring:
Stereo ("HIFI"): one NL4MP socket left channel pins 1+/1- right channel pins 2+/2- Power ("PA) Standard: three NL4MP sockets "A" socket: left channel pins 1+/1- "B" socket: right channel pins 1+/1- Bridged mono: "M" socket: left channel pins 1+/1- right channel pins 2+/2- BI-Amp: one NL4MP socket low frequency pins 1+/1- high frequency pins2+/2- Cable Wiring:
Stereo ("HIFI"): NL4FC/NL4FX/NL4FRX on amplifier end, four conductor cable splits into two pairs with NL4FC/NL4FX/NL4FRX on each end Power ("PA) Standard: a two-conductor cable for each channel with NL4FC/NL4FX/NL4FRX on both ends Bridged mono: a special two-conductor cable, on both ends wired to pin 1+/2+ of NL4FC/NL4FX/NL4FRX BI-Amp: a four-conductor cable on both ends wired to pins 1+/1-, 2+/2- ofNL4FC/NL4FX/NL4FRX Speaker Wiring:
Stereo ("HIFI"): one NL4MP per speaker left speaker pins 1+/1- right speaker pins 2+/2- Power ("PA) Standard: NL4MP pin 1+ to speaker coil "+" NL4MP pins 1- and 2+ to speaker coil "-" Bridged mono: NL4MP pin 1+ to speaker coil "+" NL4MP pins 1- and 2+ to speaker coil "-" BI-Amp: one NL4MP socket low frequency pins 1+/1- high frequency pins2+/2-